Move from a Solana account into Arbitrum EVM
Solana uses Solana accounts and SOL for source fees, while Arbitrum uses an EVM 0x account and ETH for destination gas. Confirm the destination token contract and do not paste a Solana address into the EVM destination field. WETH is read from its Solana mint or native account, while DAI arrives at the quoted Arbitrum native or contract representation.
WETH mint and SOL fee checks
Base58-encoded Solana account address SOL is the native gas asset for Solana. A Solana source signs over accounts or token accounts, identifies SPL assets by mint, and spends SOL for transaction fees. WETH leaves through a wrapper contract and needs native chain gas. A WETH token balance cannot pay the gas required to submit its own transfer. The mint/account selected by the quote must match the source wallet balance.
Arbitrum contract and 0x receiving checks
EVM 0x account address ETH is the native gas asset for Arbitrum. An Arbitrum receipt appears on the Nitro L2 ledger under an Arbitrum token contract or native ETH balance; later spending needs Arbitrum ETH while L1 settlement continues separately. The receiving wallet must recognize the exact destination DAI contract. Peg intent does not guarantee that a bridged representation has the same liquidity or issuer path. A Solana address cannot receive this EVM-side output.
Receiving stablecoin DAI
DAI is a crypto-backed dollar-oriented stablecoin whose canonical and bridged contracts vary by network. Its peg design does not make two network representations interchangeable. The destination wallet must support the exact Arbitrum representation. The route converts a token source into a stablecoin balance; the destination ticker alone is not a contract check.
WETH unwrap or exchange input check
WETH is a contract wrapper for ETH. It can be transferred as a token but cannot replace the native gas balance required by the network. On this route WETH is the source token on Solana. Its token balance, approvals, and contract transfer behavior are separate from the native coin used for network gas.
Mistakes specific to WETH Solana to DAI Arbitrum
Route-specific mistakes include sending on a network other than Solana; using a destination that is not valid for Arbitrum; running out of SOL before the source transaction is submitted; assuming solana and evm addresses are interchangeable; selecting a stablecoin by ticker without checking its network contract; treating a wrapped token as the native gas asset. A Solana source signs over accounts or token accounts, identifies SPL assets by mint, and spends SOL for transaction fees. WETH leaves through a wrapper contract and needs native chain gas. A WETH token balance cannot pay the gas required to submit its own transfer. An Arbitrum receipt appears on the Nitro L2 ledger under an Arbitrum token contract or native ETH balance; later spending needs Arbitrum ETH while L1 settlement continues separately. The receiving wallet must recognize the exact destination DAI contract. Peg intent does not guarantee that a bridged representation has the same liquidity or issuer path.
WETH input identity and handling
WETH is classified as a wrapped asset for this route. WETH uses a wrapped contract asset on Solana. The recorded Solana representation uses 9 decimal places. WETH leaves through a wrapper contract and needs native chain gas. A WETH token balance cannot pay the gas required to submit its own transfer.
DAI output identity and receiving
Dai is classified as a stablecoin for this route. DAI uses a network-specific contract asset on Arbitrum. The recorded Arbitrum representation uses 18 decimal places. The receiving wallet must recognize the exact destination DAI contract. Peg intent does not guarantee that a bridged representation has the same liquidity or issuer path.